I recently had a Viper remote start system installed on my 2005 Lexus. When I first got it installed, I noticed that the parking lights would flash twice when unlocking the car, and once when locking the car if I used the Viper fob. Today I noticed they no longer flashed when locking and unlocking. How did I disable this feature? I had to have done something because I know it is hooked up to flash as it worked before.
Answers (1)
To enable parking lights flashing when locking and unlocking your car with a Viper remote start system, you'll need to follow the specific programming instructions outlined in your Viper user manual. The process may vary slightly depending on the model of your Viper system, so it's essential to refer to the documentation that came with your particular unit.
Here's a general guide that may help you get started:
Refer to the User Manual:
Start by locating your Viper remote start system user manual. This guide should provide step-by-step instructions on how to program different features, including the parking lights flashing.
Access Programming Mode:
Most remote start systems have a programming mode that allows you to customize various settings. This often involves a combination of button presses on the remote control or a series of actions within the vehicle.
Enter the Programming Sequence:
Follow the instructions in the manual to enter the programming sequence. This usually involves turning the ignition key to a specific position, pressing certain buttons on the remote control, or following a specific sequence of actions.
Select Parking Lights Option:
Once in the programming mode, navigate to the option that controls the parking lights' behavior during locking and unlocking. This might be labeled as "Light Flash," "Pathway Lighting," or something similar.
Adjust Settings:
Depending on your preferences and the available options, you may be able to choose the number of flashes or other parameters related to the parking lights. Use the remote control or vehicle controls as instructed to make the desired changes.
Exit Programming Mode:
After adjusting the settings, follow the instructions to exit the programming mode. This often involves turning the ignition key again or pressing a specific button on the remote control.